- Fig. 1 Detail of headliner: Rotary control for sun roof
Applies to vehicles: with sun roof
Tilting open and closed
Important: The switch for the sun roof must be in the -0- position Fig. 1.
To tilt the sun roof fully open, briefly press the switch.
To fully close the sun roof, briefly pull the switch WARNING!.
To set an intermediate position, press or pull the switch until the sun roof has reached the desired position.
Opening and closing (version 1)
To slide the sun roof open to the position for low wind noise, turn the switch to position -1- (until you feel a resistance).
To fully open the sun roof, turn the switch past the point of resistance to position -2- and hold the switch.
To completely close the sun roof, turn the switch to position -0- WARNING!.
Turn the switch to the desired position to set the roof to an intermediate position.
Opening and closing (version 2)
To fully open the sun roof, turn the switch to position -1-.
To completely close the sun roof, turn the switch to position -0- WARNING!.
Turn the switch to the desired position to set the roof to an intermediate position.
The sliding sun blind can be opened and closed manually in any position. The sun blind opens automatically when you slide open the sun roof.
The sun roof can be operated for about ten minutes after the ignition has been switched off. The switch is deactivated immediately when one of the front doors is opened.
Take care when closing the sun roof. Careless or uncontrolled use of the sun roof can cause injuries. For this reason, always take the ignition key with you when leaving the vehicle.
Caution!
You should always close the sun roof when leaving the car. Sudden rain could seriously damage your vehicle's interior equipment, especially the on-board electronic systems.
Note
Details on the convenience open/close function Link.