Applies to vehicles: with HomeLink
The procedure described above is suitable for programming both fixed code and rolling code systems.
Programming a button
Switch on the ignition.
There are two ways to program a button: press the particular button Fig. 1 you would like to program. The MMI* will guide you through the programming routine. Or:
Select: Function selector button CAR > control button Car systems* > Vehicle settings > Garage door opener Program garage door opener.
Select the button you would like to program.
Follow the directions on the MMI*.
If the garage door drive also has to be synchronised with the HomeLink module, please refer to the instructions for the garage door drive.
Pressing a button
To open the garage door, press the programmed button. The diode -A- will light up or flash.
To close the garage door, press the button again.
Erasing/reprogramming the buttons
To erase the settings of all programmed buttons at once, select: Function selector button CAR > control button Car systems* > Vehicle settings > Garage door opener > Clear program settings > Yes. Programmed buttons cannot be erased individually. Reprogram the buttons if necessary.
To reprogram an individual button, proceed as though you were programming the button for the first time.
Displaying the version/status/regional code
Select: Function selector button CAR > control button Car systems* > Vehicle settings > Garage door opener Version information.
Note
- Not all vehicles are equipped to program the system using the MMI*.
- The required distance between the hand-held transmitter and the HomeLink module inside the radiator grille Fig. 2 depends on the system you are programming.
- With some types of garage door opener, you may need to briefly release the button during programming and then press it again.
- For security reasons we recommend that you delete the programming of the buttons prior to selling your vehicle.