- Fig. 1 Ignition lock: Ignition key positions
Applies to vehicles: with ignition lock
Insert the key in the ignition lock to switch on the ignition and start the engine.
Switching the ignition on/off
To switch on the ignition, turn the ignition key to position -1-.
To switch off the ignition, turn the ignition key to position -0-.
Starting the engine
Press the brake pedal and move the selector lever to position P or N.
Turn the ignition key to position -2-. The ignition key automatically returns to position -1-. Do not press the accelerator.
If the engine fails to start immediately, switch off the starter and try again after about 30 seconds. To start the engine again, turn the ignition key to position -0-.
- Never run the engine in confined spaces. The exhaust gases are toxic – risk of poisoning!
- Never remove the key from the ignition while the vehicle is moving. This would cause the steering lock to engage and you would no longer be able to steer the car.
- Always take the key with you when you leave the vehicle. Otherwise the engine can be started or power-operated equipment such as the electric windows can be used. This could result in serious injury.
Caution!
Avoid high engine speeds, full throttle and extreme load conditions until the engine has reached its normal operating temperature; otherwise this can damage the engine.
Note
- If it is difficult to turn the ignition key to position -1-, move the steering wheel (to take the load off the steering lock mechanism) until the key turns freely.
- When starting from cold the engine may be a little noisy for the first few seconds until oil pressure has built up in the hydraulic tappets. This is quite normal and no cause for concern.