Applies to: vehicles with garage door opener (HomeLink)
Some devices require rolling code programming.
Identifying a rolling code
After a rolling code has been successfully programmed (while standing in front of the car), the yellow LED will be permanently lit when you get into the car. The next time a button is pressed, the LED goes out and then flashes in green while the garage door opener transmits a signal. If the button is pressed subsequently, the green LED will flash while the garage door opener is transmitting the signal.
Program the rolling code as follows:
Activating a system s drive unit
Locate the programming button on the system s drive unit. The exact location and colour of the button may vary depending on the type of system.
Press the programming button on the system s drive unit (this will normally cause an indicator lamp on the unit to light up). You now have about 30 seconds to start and complete programming of the button in the operating unit.
Programming the button in the operating unit
Press the previously programmed button in the operating unit for 2 seconds.
Press the button for 2 seconds again to complete rolling code programming.
For some systems, the button may have to be pressed a third time to complete the programming sequence.
After programming, the system should recognise the signal and respond when the button in the operating unit is pressed. Now the other control buttons can be programmed as required.
Note
- Having a second person assist you makes programming of the rolling code easier and faster.
- If you encounter problems programming the rolling code you may find helpful information in the operating instructions of the system you wish to operate.